Motor çalışmıyor

2 gün, 12 saat önce
comment 11 yorum

Arkadaşlar, 3.2 ford ranger wildtrak'imde bir sorun var... garajda 3 gün kaldıktan sonra motor araba çalışmıyor... bataryanın sorun olduğunu düşündüm, yeni bir aku taktım... ama hâlâ araba çalışmıyor... starter dönmeyi bırakıyor ve motoru çalıştıramıyor... dönüyor ama duruyor. Bir şey motorun çalışmasını engelliyor... gösterge panelimde hiç uyarı ışığı yok... aynı sorunu yaşayan var mı? Bence starter sorunlu... bir fikir?

Araç Bilgileri

Marka Ford
Model Ranger
Model Yılı 2016
Donanım Ford Ranger Wildtrak
Kilometre 59500

Yorumlar 11

Yorum yapmak için giriş yapın.

J John 17.11.2020 02:28

Same goes in ours may I know what fix your problem?

thumb_up 10
N Nokesy 21.04.2021 11:35

This is mine today, anyone know the issue?

thumb_up 15
K Karl1975 19.06.2021 09:39

Hey mate, what did you find the problem was, mine has just started doing the same thing.

thumb_up 4
L Luke 12.07.2021 09:51

@Karl1975Did you find what it was I now have one doing the same thing

thumb_up 6
K Karl1975 15.07.2021 05:35

@LukeHey mate it was a loose wire on the battery terminal, not the terminal itself but one of the wires that bolts to the terminal.

thumb_up 6
C Cinnymel 12.01.2022 19:52

Yes. My 2002 Ford ranger xlt v6 3.0l truck wouldn't start. Installed new battery, even though battery, voltage regulator, alternator, starter all checked out good. I put a new Ford ignition starter coil pack module that goes where a distributor cap used to in older cars and it fixed problem so far. It was part of control computer chip.

thumb_up 2
C Cinnymel 18.03.2022 13:31

Has anyone else experienced manual transmission problems. I have a 2002 Ford Ranger xlt v6 3.0l and have had the clutch and manual transmission fixed in October of 2020. $1600 at automotive shop which counted tge Emergency brake cable broke and rear disc drums replaced. Now, a year and a half later gears are sticking and doesn't want to go into gear.

thumb_up 4
P patf 30.07.2024 23:06

sounds like it could be the clutch hydraulics bleeding off pressure or the pilot bearing in the clutch binding up. if you can shift gears with the engine off but not when it is running its likely one of those two things. otherwise maybe internal transmission issue but sounds more like clutch isnt disengaging to me

thumb_up 1
F Florida D 06.01.2023 03:39

The roll over switch Up under the passage side below the glove box

H HENDO 12.03.2023 23:01

Scan and clear all fault codes , should fix it.

thumb_up 1
C Cooraz 06.01.2024 10:25

Maybe need to reset the battery monitor sensor. In the new models there's a 'turn ignition/ press brake' - sequence... but I'm not sure how or if you can do it yourself in older models. Need a mechanic with a computer to hook up to it and reset the battery monitor sensor. Takes all of 10 seconds to do. Ask them how much for a call out to do it and haggle them with the leverage that it will only take them 10 seconds of they try charging anything too ridiculous.

thumb_up 1