laktozssuz · 22.09.2017 21:16
Sadece yolcu tarafı düşük ışıkta 2 volt var. Yüksek ışık hala çalışıyor
Mine too can't find any fuse problems also replaced globe
Have any one had this problem and had it fixed
Had to reset computer. Over load fault on low beam
Low beam is not working passenger side but the high beam is working perfectly.
Hi emil may i know how you solve the problem of your ranger ? Thanks
I fitted two supposedly 'compatible' with 2014 PX1 Ranger LED headlamp bulbs and the rh low beam came on then went out, refitted original bulb, no light, the LH low beam also failed a few seconds later. High beam operates however, need BCM reset, not happy I have sent away to a Victorian supplier of a 'specific' Ranger Canbus conversion cable in order to get around flicking a code again, not tried as yet however...I also have a PJ PK model and there was no problem with similar LED bulbs.
PS Rangers also have to be Canbus modified when fitting trailer brake units, Ford can supply a cable I believe, something also to do with BCM with the brake circuit triggering code when used a trigger for brake controller, can't use rear brake light as trigger ,I had heard about this but not the headlight difficulty.